Hydraulics, Leroy Dean & Company, we can show you how easy it is to implement a proactive contamination control program.

particles normally missed by the main filter, this removal of the ultra fine debris at source immediately reduces the risk of malfunctioning control valves as well as dramatically reducing the erosion of the hoses and seals caused by these fine particles. This stops the sand blasting effect.

In addition Filtakleen takes away the risk of silting of the suction filters which can cause pump damage through cavitation. In fact, the finer tolerances of today's machinery makes the removal of 1-25 micron wear particles a necessity and so by addressing this need with Filtakleen, you are creating Major Long Term Benefits in both component life and circuit operation.

100% Water Removal-Stop Acidity

By its ability to remove all water content Filtakleen reduces dramatically the normal acid buildup in the oil so avoiding the corrosion and chemical degradation of all the seals and hoses as well as preventing unnecessary pump wear and cavitation through invert emulsions.

SPECIAL NOTE Filtakleen is a supplement to the main filters and by continually taking only a small amount of oil from the system we are able to perform a thorough cleaning operation on the oil.

Major Long Term Benefits—

Saves wear on component part and reduces maintenance costs.
Prevents fine tolerance valves from sticking, for maximum production time.
Fast, easy cartridge changes without stopping machinery or production.
Saves on oil and oil disposal costs.
Improves the system filter life and reduces replacement costs.
Reduces unnecessary pump wear and decreases cavitation.
Eliminates dirt that causes corrosion of hoses, seals and control valves.
One micron/100% water removal.
Never change your hydraulic oil again, with the use of our filter.

Planned Maintenance—

By incorporating a ball valve into the inlet side of the Filtakleen circuit you are able to replace the FK element, a 5 minute no mess job, without the need to shut down the hydraulic pump. Simply turn the ball valve to off, unscrew the lid bolt and remove the element. As good as an oil change.